Navigation:  WebOffice > Best Practices > Put as much Configuration Information as possible into the Map Document > ArcMap Layer properties

WebOffice 10 R3 takes the ArcMap layer scale (visibility) ranges into consideration.

See Chapter Table of content for detailed information on what you should take into consideration when specifying ArcMap layer scale ranges.

 

General recommendations are:

 

•Every layer should have a defined scale range,

•On a certain scale the count of features rendered in the map for a specific layer should at maximum be about 100 objects. This is a very rough estimate anyway, because data fetch time, layer symbol renderers etc. influence the rendering time,

•Think about used layer symbols and renderers. Complex renderers take a lot more time to render then simple renderers.